i can aim, but cant move (since the update)

[POPEYE_tsm]

HI,
Since the update, i joined up, and couldnt move. Mouse controls are fine, just the arrow keys stopped working. In spec mode, i can move about incredibly slowly, but it game, nothing. The control settings are fine.

Anyone else?

update:
I didnt really want to admit this, but i use a gamepad and mouse for this game, but the arrow keys dont work when gamepad is plugged in anymore. There seems to be gamepad section under controls, is that new? These settings makes no difference for me anyway

[barbarossa]

http://www.quakelive.com/forum/showt...August-31-2010

[POPEYE_tsm]

Thanks alot for your time on that. I havent tried it yet, but for anyone else who might have this issue, this hopefully should be the fix (as taken from your link)

* In the console set 'in_joystick 1' to enable gamepad support.
* If you experience that you are unable to move, set 'in_joyballscale 1'.

[*BIGCHRONIC]

i can move but i cannot seem to configure the mouse to the joystick to look around. there is no option for it either.

[*q3satori]

Yep... my old Q3 config that used to work with QuakeLive now fails, finally found that the
joyballscale had to be over 1.0 to work and 2.5 for it to feel normal to me again.

I have noticed that when joystick is enabled, it locks out the keyboard ASWD controls.

YawSpeed seems a bit slower now too, so I up'ed that setting a bit as well.

[*BIGCHRONIC]

Is that what controls view?